jes notes Index Gallery . Clavichords Cyclecar Dehumidifier Financial Data FreeCAD MSVA Philosophy Signed Distance Functions Shaft passers Snap issues

2026-11-06

Last modified: 2026-11-06 22:49:44

< 2026-11-05 2026-11-07 >

Plasma cutter

I've been trying to get this working this evening.

Problems are that it doesn't penetrate very fast, doesn't cut very fast, and leaves a lot of slag and a heavily parallelogram kerf.

Turning up the air pressure and removing a restrictive section of air hose seems to have helped with the slag but not necessarily as good as it ought to be.

I can't find anything wrong either mechanically or in the nozzle that looks like it would cause a parallelogram kerf, it's about 20° away from vertical.

I eventually gave up trying to debug it with short cuts in 4mm steel and tried to cut out some actual shapes in 3mm steel.

Cutting out a square worked:

So I moved on to trying to cut out a heart:

https://www.youtube.com/watch?v=T8ezYS-_n2o

But it stopped about 3/4 of the way around! It blew the fuse in the extension lead, annoying. I had the compressor, plasma cutter, CNC controller, and laptop all plugged into the same one. I think just moving either the compressor or plasma cutter to a different socket would be enough.

The heart was at 400 mm/min with 1.5 second pierce dwell, in 3mm steel.

The pierce was obviously not enough, but after it penetrated it pretty much stayed penetrated, albeit leaving a lot of slag on the bottom, unsure how normal that is.

And the bevel is still there. I've ordered a new set of consumables for £22.99 and will refresh the nozzle and electrode etc. just to see if that helps. Total expenditure on this now £125.59.

I wonder if ChatGPT can debug any further from the pics here?

Also that one bearing on the X rail is getting absolutely showered with sparks, I ought to put a cover over it.

The arc turned green just before it blew the fuse, apparently the arc turning green means the electrode has failed! So this might be a good clue. That may also be why it blew the fuse.

Things to look at next are:

Lol!! Watching the video back you can see I didn't attach the ground clamp in that last cut!! Pretty good performance considering. So that was all done on the pilot arc only.

FML. Must remember to use the ground clamp. Probably eventually I will have it clipped to the water tray and then can't forget it.

< 2026-11-05 2026-11-07 >