Last modified: 2026-11-05 20:18:17
< 2026-11-04 2026-11-06 >Torch mounted on platform:
I guess now I have to find out if it works.
I tried various combinations of settings but didn't really get anything satisfactory.
This is the kind of thing I ended up with:
I don't know why the cut is going off to the side so badly, the clamp could plausibly be misaligned slightly but not by that much.
That's with the full 30 amps from the plasma machine, 3 second pierce delay, and I think 180 mm/min travel speed, in 4mm steel.
It's kind of nerve-wracking to run, I keep thinking the sparks are going to ignite some sawdust.
I have cut through this steel with the plasma cutter by hand, but come to think of it that went badly sideways as well, but I just assumed I was holding it wrong.
ChatGPT suggests it could be a damaged or misaligned nozzle or electrode.
Apparently the Parkside PPS 30 B2 is meant to come with spare consumables but I don't think mine did. Possibly the seller found that the machine didn't work properly so fitted the spare consumables so that it looked unused and then sold it on?
Photos of the nozzle/electrode:
I then reassembled it and did a a manual test cut:
Which, idk, maybe seems better than my original test cut when I first got it?
So maybe this is resolved now? Need to check again under CNC control tomorrow.
And with the nozzle off we can see that the electrode looks pretty parallel to the machine Z direction:
I also noted that the pressure shown on the gauge on the back of the plasma cutter dropped to 3.75 bar during use, the manual says it needs 4 bar but seems to me that 3.75 bar should be close enough to work.
< 2026-11-04 2026-11-06 >