jes notes Index Gallery . Clavichords Cyclecar Dehumidifier Financial Data FreeCAD MSVA Philosophy Signed Distance Functions Shaft passers Snap issues

2026-11-15

Last modified: 2026-11-15 10:01:35

< 2026-11-13

Plasma cutter current measurement

Rather than buy a DC clamp meter, I think the plan is:

And then if it's broadly 20A or whatever I selected on the dial then we know there is enough current and poor cutting performance is due to something else. And if there's not enough current then the plasma cutter is maybe defective?

Also would be good to measure the AC voltage the plasma cutter is getting during cutting. If the wiring is too resistant then the AC voltage will drop too much, especially given the high current it is drawing, and that may exacerbate the problem if it then tries to draw even more current to make up for the low voltage.

< 2026-11-13