Last modified: 2026-11-11 14:54:20
< 2026-11-10 2026-11-12 >A good bending former design here: https://www.youtube.com/watch?v=R7y5MIux_uQ
So that is a plasma cut plate top and bottom, with 3d-printed form in between, made of 2 parts so printed without overhangs. Has a bush through the middle for the pivot, and has a little clamp thing at the side to hold the tube in the former.
They are using a fancy hydraulic bender, I am thinking I would clamp the tube to the former and then have a lever centered on the centre of the former, with a roller on it, that I will pull around the former to bend the tube.
I need to put a 50° 200mm radius bend in 35mm diameter 2mm thickness steel tube.
Here's a start:
So there are 2 metal plates and 2 3d-printed formers for each of the main large former and the roller.
They'll be bolted together each with 6x M10 nuts and bolts.
The roller takes a 608 bearing in the plate on each side. I'm guessing the plasma-cut surface won't be ideal for this but probably just give it a go, can always machine it if necessary.
The main large former just has a 60mm hole all the way through the plates and the 3d prints, may change the diameter on this to suit whatever short piece of bush I can find.
Then we need a big lever for the roller, with clearance for the M10 nuts and bolts.
And need some plan for how to clamp the tube and main large former to each other and to the bench. And then done?
The line marks on the main large former plates are to show the 0° nad 50° positions, to give an idea of when the bend is at the right angle.
ChatGPT review is:
Point 4 seems wrong because in order to come around the former it would have to bend, no?
I was thinking of using 608 bearings on the roller to reduce the friction so that it is easier to bend. I think I'll just try it, if it damages the bearings then I probably don't even care as long as it makes my 2 bends.
In a way it is encouraging that the loads required to bend this tube are so high because that means it won't bend when it's on the car.
One annoying thing is that I can't bolt the lower plate down to something without blocking the path of the lower arm of the lever. What if the lever only had one arm? Would that work or would it just bend?
I guess I can 3d print the roller parts now while I think about it, the roller is unlikely to need to change.
I am wondering about bolting this down to the workbench to use it. I don't currently have any holes in the workbench, which I like, but maybe if I can't think of anything else large and sturdy to use, putting holes in the bench is the best idea? Can always fill them after.
Plasmanest can nest the current plasma cut parts on to an A3 sheet like so:
But I may be adding features for mounting which make it not fit annoyingly.
I've moved the machine to its actual place:
Haters will say you can't run a plasma cutter on a wooden shelf.
I still plan to bolt the "legs" down so that it is held a bit more firmly, and keeps the legs square.
And I need to make a slat table or whatever to sit inside the water tray.
< 2026-11-10 2026-11-12 >