2026-04-12

Last modified: 2026-04-13 14:05:55

Keyboard Glockenspiel Case

Solution to yesterday's problem: make the top thinner

And I'm going to forgo adjustable bar height, in favour of iterating on the damper design until it works properly without requiring adjustment.

I will cut some sort of slots in the top cover, and the tone bars will be held by 3d-printed TPU pieces that push it into the slot, and the tone bar pushes on top. Using the flexibility to push through the slot in the board, and the hole in the tone bar, and then pop out the other side, maybe like this: