watchdog - monitor multiple inputs for a "heartbeat"
|
loadrt watchdog num_inputs=N |
You must specify the number of inputs, from 1 to 32. Each input has a separate timeout value.
process
Check all input pins for transitions, clear the ok-out pin if any input has no transition within its timeout period. This function does not use floating point, and should be added to a fast thread.
set-timeouts
Check for timeout changes, and convert the float timeout inputs to int values that can be used in process. This function also monitors enable-in for false to true transitions, and re-enables monitoring when such a transition is detected. This function does use floating point, and it is appropriate to add it to the servo thread.
watchdog.input-n bit in
Input number n. The inputs are numbered from 0 to num_inputs-1.
watchdog.enable-in bit in (default: FALSE)
If TRUE, forces out-ok to be false. Additionally, if a timeout occurs on any input, this pin must be set FALSE and TRUE again to re-start the monitoring of input pins.
watchdog.ok-out bit out (default: FALSE)
OK output. This pin is true only if enable-in is TRUE and no timeout has been detected. This output can be connected to the enable input of a charge_pump or stepgen (in v mode), to provide a heartbeat signal to external monitoring hardware.
watchdog.timeout-n float in
Timeout value for input number n. The inputs are numbered from 0 to num_inputs-1. The timeout is in seconds, and may not be below zero. Note that a timeout of 0.0 will likely prevent ok-out from ever becoming true. Also note that excessively long timeouts are relatively useless for monitoring purposes.
GPL